return to first page linux journal archive
keywordscontents

NIC Configuration for Red Hat 6.0

The first two files below should already be set up, as they would have been configured during the installation of Red Hat 6.0. The order of the lines in the files does not matter, and some minor modifications may need to be made as shown below:

The purpose of the /etc/sysconfig/network file is to determine the host name and default gateway details of the system. In this example, GATEWAY points to the ISP-provided gateway via eth1.

NETWORKING=yes
FORWARD_IPV4=yes
GATEWAYDEV=eth1g0
GATEWAY=193.181.132.1
HOSTNAME=fw2
The file /etc/sysconfig/network-scripts/ifcfg-eth0 is used to configure eth0 for connection to the local LAN.

DEVICE=eth0
IPADDR=192.168.0.1
NETMASK=255.255.255.0
NETWORK=192.168.0.0
BROADCAST=192.168.0.255
ONBOOT=yes
BOOTPROTO=none
You will need to create the following file, and its permissions should be set to 644 (chmod 644 ifcfg-eth1). Use the file variation below that pertains to your setup. If your ISP has given you a static IP address, use the first example. If your ISP told you to use DHCP, use the second example. See the main text for more information on setting up the second Ethernet port.

The file /etc/sysconfig/network-scripts/ifcfg-eth1 configures eth1 for connection to the ISP using a static IP address assigned by the ISP.

DEVICE=eth1
USERCTL=no
ONBOOT=yes
BOOTPROTO=none
BROADCAST=193.181.132.255
NETWORK=193.181.132.0
NETMASK=255.255.255.0
IPADDR=193.181.132.24
The file /etc/sysconfig/network-scripts/ifcfg-eth1<\n> configures eth1 for connection to the ISP using a dynamically allocated IP address assigned (via DHCP) on the fly by the ISP.

DEVICE=eth1
USERCTL=no
ONBOOT=yes
BOOTPROTO=dhcp
BROADCAST=
NETWORK=
NETMASK=
IPADDR=